Intermec CK30

Using the Terminal Emulation MenusChapter —4
102 TE 2000
 5250 Terminal Emulation Programmer’s Guide
1) Set-up Parms (6400, 5055, 59XX, 17XX, 11XX)
This is password-protected to prevent u nauthorized users from changing
parameters. You can customize the parameter’s CONFIG.DAT setup file
to change the password. See Chapter 5, “Customizing Your Configuration.”
Changed parameters apply to the current session. If more than one session
is available, use the 7) More > 2) Save Parms > 4) Session Menu to verify
or change the current session before going to the next session. To open the
1) Set-up Parms menu, press [1], [Enter], then type “cr52401” at the
prompt to access the following menus.
1) Backlight is
for 6400, 17XX,
11XX
3) Remote Disp is
for 17XX
Controller Type
1)
2) RTC/WTP
3) Direct Connect
Protocol Opts
1) Host View Sze
2) Data Stream
3) Extended Cmds
4) 5250
5) 3270
6) VT220
7) Native
Protocol
1) SST
2) SST-Diag Mode
3) Security ID
Scanner Type
1) No Scanner
2) Wand
3) Laser
4) Wand Emulate
5) Auto Detect
Display Opts
1) Backlight
2) Cursor Mode
3) Remote Disp
Cold Start
Enter “Y”
To Cold Start
terminal:
Set-up Parms
1) Menu Password
2) Print Device
3) COM Select
[1]
[3]
[5]
[4]
[7][6]
7) Native is blank
if UDP Plus or
TCP/IP
3) Security ID is
for Proxim radios
2) Print Device is
for 6400
3) COM Select is fo
r
5055
3) Direct Connect
is for 6400, 5055 with
TE/IP
Set-up Parms
1) Communication
2) Barcode Parms
3) Protocol Opts
4) Display Opts
5) Radio Comm
6) Cold Start
7) More
2) Wand,
4) Wand Emulate,
5) Auto Detect are
for 59XX, 17XX,
11XX
2) RTC/WTP
is for 6400, 5055,
59XX, 11XX, 17XX
with RTC
[2]
[2]
Scan Options
1) Redundancy
2) MOD 10 Check
3) Concatenate
4) BC Type Char
5) Stream Scan
6) Scan All Flds
7) More
1) Redundancy is
for 6400, 59XX,
17XX, 11XX
4) BC Type Char is
for 6400, 59XX,
17XX, 11XX
3) Concatenate is
for 6400, 5055