Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
175TE 2000
 5250 Terminal Emulation Programmer’s Guide
To assign a name to another session, press [1] to switch to that session,
return to the Session Menu, then press [4] to assign a name to that session.
Set Hot Key
Use Cursor Up
And Down Keys
To Adjust
<xx>
Select Session
Use Cursor Up
And Down Keys
To Adjust
Session: X
<datastream>
Host: xxxx
Session Menu
1) Switch
2) Set Hot Key
3) Copy Setup
4) Session Name
[1]
[2]
Session 1
Session Name
[4]
4) Session Name is for
700 Series, CK30,
CK31, CV60
[1]
For 700 Series, CK30, CK31, CV60
For 2415, 2425, 2435A, 2455,
2475, 248X, 6400, 5020, 5055,
59XX, 17XX, 11XX, CK31
1 Cursor left or right, then press [Enter]; or press a number to pick a session.
2 The IP address or DNS name assigned to the selected session.
3 The terminal emulation assigned to the selected session.
[3]
1
2
3
1
3
Restarting Term inal Emulation
Note: The reset firmware bar code is not supported on the 5020, 59XX,
17XX, 11XX, 700 Series, CK30, CK31, or CV60 Terminals. Instead, do
the cold-start function to exit the TE 2000 application and return to the
Windows C E main menu.
You need to r estart your TE 2000 application if you are having problems
or if you want to reconnect to the host with a new configuration. Restart-
ing your TE 2000 application also clears the auto-login information, pre-
venting another user f rom establishing a T E 2000 session using your login
information.