Intermec CK30

Extended CommandsChapter —7
308 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Return Codes for Transmit Only
The terminal puts the return code response in an input field in the display
buffer at Line 24, Column 1. It simulates the [ENTER] key to return the
value to the host.
Use the Start Field order to return a code for this operation. The following
chart lists return codes.
Code Description Column
0 Good status, transaction complete. (None)
1 Not enoug h memory. Or, incorrect setting for speed, nu mber of data bi t s, number of stop
bits, or flow control timeout.
4, 6, 7, 11–12
2 No delimiter (#) on data stream. (None)
3 Timeout while using CTS flow control (6400, 5055, 59XX, 17XX, 11XX). (None)
4 Timeout while using DTR flow control (6400, 5055, 59XX, 17XX, 11XX).(None)
5 Timeout while using XON/XOFF flow control. (None)
6 Improper return field. (None)
8 Error in AID code. (None)
C Incorrect setting for CTS, DTR, or XON/OFF flow control. 8, 9, 10
E Incorrect se tting for data parity. 5
f Timeout. No acknowledgment was received from the RD5500 Remote Display (applies to
the 17XX Terminal).
(None)
o/O* Overrun of UART receive register. (None)
p/P* Data parity or framing error. (None)
R Syntax error from RD5500 Remote Display (not the expected ch aracter; no character error
was detected). (Applies to the 17XX Terminal.)
(None)
* An uppercase letter indicates an error from the RS-232 device. A lowercase letter indicates an error from the
RD5500 Re mote Display (applies only to the 17XX T erminal).