Using the Terminal Emulation Menus—Chapter 4
171TE 2000
5250 Terminal Emulation Programmer’s Guide
7) More (Main Menu 2)
Select 7) More to open the M ain Menu 2 screen.
Main Menu 2
1) Keyboard Opts
2) Save Parms
3) Cloning Opts
4) Session Menu
4) Session Menu is for 2415 (WTP), 2425
(WTP), 2435A (WTP), 2455 (WTP), 2475 (WTP),
248X (WTP), 6400, 5020 (TCP/IP), 5055, 17XX,
11XX, 700 Series, CK30, CK31, CV60
3) Cloning Opts is for 59XX, 17XX, 11XX
1) Keyboard Opts
Use 1) Keyboard Opts > 1) Type-Ahead to key in information when the
terminal cannot immediately send data to the host computer.
1) Type-Ahead enters information when the terminal cannot immediately
send data to the host.
Keyboard Opts
1) Type—Ahead
This stor es keystrokes after the Input Inhibited annunciator (below) ap-
pears on the status line, and then saves them for the next input field.
Type-ahead is enabled by default.
X
Input Inhibited annunciator
2) Save Parms (Parameters)
Use 2) Save Parms to retain the changes made to TE configuration set-
tings. When saved, changes become the default settings for the terminal.
Note: Use this option sparingly. Each time it is used, additional memory
space is occupied because previously saved changes are not erased. The
memory cannot be r ecovered on 59XX, 17XX, and 11XX Terminals with-
out reflashing.
Ensure that the parameters are correct before choosing 2) Save Parms.
When selected, you are prompted to enter a seven-character password. The
default password is “cr52401,” which can be altered with a custom config-
uration to be a string of 1 to 10 characters long. After you enter the cor-
rect password, your changes are written to Flash.
To Next Page
Loading...
