Intermec CK30

Extended CommandsChapter —7
328 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Interleaved 2 of 5
If Interleaved 2 of 5 is enabled, select the maximum and minimum lengths
and the first and second fixed bar code lengths according to requirements.
Note that a “b” indicates a 1-byte space. Refer to the manufacturer’s bar code
specifications for more information.
Interleaved 2 of 5 Character s — Line 1, Columns 29-37
(6400, 5055, 59XX, 17XX, 11XX)
Character Description
29 0=Interleaved 2 of 5 disabled; 1=Interleaved 2 of 5 enabled; b=No change from current setting
30–31 XX=maximum length Interleaved 2 of 5; bb=No change from current setting
32–33 XX=minimum length Interleaved 2 of 5; bb=No c hange from current setting
34–35 XX=1st fixed length for Interleaved 2 of 5 Bar Code; bb=No change from cu rrent setting
36–37 XX=2nd fixed length for Interleaved 2 of 5 Bar Code; bb=No change from current setting
Return Codes for Scan Bar Code
The Scan Bar Code Parameters return code is the status sent to the host
computer; the code indicates if the extended command was successful. The
terminal returns data and the extended command’s status to the host com-
puter in the \\X<CR> format where X isthereturncodelistedinthefol-
lowing chart. The terminal simulates the [ENTER] key to return a value
to the host computer. If a hexadecimal number is entered wrong, the
return code defaults to “0.”
Code Description
0 Good status, transaction complete
1 Bad status, transaction incomplete