Using Terminal Emulation ApplicationsChapter —2
16 TE 2000
5250 Terminal Emulation Programmer’s Guide
5250 Serial Scanning
The following instructions explain how to set serial scanning options.
These instructions apply to the 2415, 2425, 2435A, 2455, 2475, and 24 8X
Terminals.
1 Connect your terminal to a serial scanner.
2 Open the TRAKKER Antares 2400 Menu System.
3 From the Main Menu, choose Configuration Menu > Communica-
tions Menu > Serial Port, then configu re the serial port parameters. See
the terminal’s user manual for help. Note that the baud rate, data bits,
stop bits, and parity for the serial scanner and the serial port must match.
Do the following to set the RS232 Stream option:
1 Open the TE configuration menus. For the correct key sequence, see
Chapter 1, “Getting Started.”
2 From the Main M enu, select 1) Set-up Parms, then enter “cr52401” at
the Enter Password prompt.
3 Select 2) Barcode Parms > 4) RS232 Stream.
To Next Page
Loading...
