Intermec CK30

Customizing Your Configuration—Chapter 5
251TE 2000
 5250 Terminal Emulation Programmer’s Guide
Downloading Files
2415, 2425, 2435A, 2455, 2475, 248X Terminals
You can use one of several methods to download a file to a 2415, 2425,
2435A, 2455, 2475, or 248X Terminal, including:
S LOADER.EXE file loader utility. Note that using this utility will auto-
matically restart the TE 2000 application.
S T24FCOPY.EXE through a serial connection from your Trakker An-
tares terminal to your personal computer
S The Download Server feature on the Intermec Application Server to a
Trakker Antares terminal loaded with UDP Plus
S A TFTP application on a personal computer or host to a Trakker An-
tares terminal loaded with TCP/IP
To use these methods, refer to your terminal’s user manual for help.
To restart your T E application, do one of the following:
S Scan the following bar code label. You can also send the Reset Firmware
command over the network. For help, r efer to your terminal’s user
manual.
Reset Firmware
*/M.*
*-.*
S Use the TRAKKER Antares 2400 Menu System to configure the Re-
sume Execution command to resume “not allowed.” Choose Terminal
Menu from the Configuration Menu and then choose Power Manage-
ment. Each time you press œ to turn on the Trakker Antares terminal,
it boots and restarts your application. See the terminal’s user manual.
S Access the T RAKKER Antares 2400 Menu System and select the TE
application through the File Manager option. For help, see your termi-
nal’s user manual.
The Trakker Antares terminal restarts your TE application using the con-
figuration saved in CONFIG.DAT.
5020, 700 Series, CK30, CK31, CV60 Terminals
From your web browser, use the ftp://<IP address> URL to download files.
For the terminal, use the Microsoft ActiveSync application like described
on page 187.