Intermec CK30

Customizing Your Configuration—Chapter 5
217TE 2000
 5250 Terminal Emulation Programmer’s Guide
Additional Parameters (continued)
Terminals using this
parameter
Values
[Session 1]
Session 2
Session 3 (700 Series, CV60)
Session 4 (700 Series, CV60)
Parameters
Key Repeat Key Repeat Enabled, [Disabled] 59XX
Program Name
(appears on
initialization and
version screens)
Program Name String, minimum length =
1, maximum length = 8
2415, 2425, 2435A,
2455, 2475, 248X,
6400, 5020, 5055,
11XX, 17XX, 59XX,
700 Series, CK30, CV60
Program Version
(appears on
initialization and
version screens)
Program Version String, minimum length =
1, maximum length = 4
2415, 2425, 2435A,
2455, 2475, 248X,
6400, 5020, 5055,
11XX, 17XX, 59XX,
700 Series, CK30, CV60
Return Result Return Re sult [Enabled], Disabled 2415, 2425, 2435A,
2455, 2475, 248X,
This is a test feature for VT/ANSI emulation; if disabled, extended commands (for #K
only) does not return a result to the host application.
5
5
,
7
5
,
,
6400, 5020, 5055,
11XX, 17XX, 59XX,
700 Series, CK30, CV60
Set-Up Parms Menu
Password
Password String, minimum length =
1, maximum length = 10
[CR52401]
2415, 2425, 2435A,
2455, 2475, 248X,
6400, 5020, 5055,
11XX, 17XX, 59XX,
700 Series, CK30, CV60
TE_SETTINGS.INI Settings
For 700 Series, CK30, CK31, CV60 T erminals with TE 2000 application
versions 8.00 or greater, the following settings are available.
Upgrading from CONFIG.DAT Configuration
Note that the settings from the CONFIG.DAT file are the same as the
settings for the TE_SETTINGS.INI file. For example, the
CONFIG.DAT setting: [Host A].Host would appear as
session_1|host_a|host = 136.179.84.76 in the
TE_SETTINGS.INI file.
All values follow the [iccu v alues] section and use the pipe character to
separate the names. The settings and literals are the same as the old
CONFIG.DAT with the exception of the use of the different naming
convention using the pipe (”|”). Below are a few values from the
CONFIG.DAT file as they appear in the TE_SETTINGS.INI file.
[iccu values]
session_1|host_a|host = 136.179.84.76
session_1|host_a|port_number = 23
session_1|destructive_bs = 0