Intermec CK30

Using the Terminal Emulation MenusChapter —4
142 TE 2000
 5250 Terminal Emulation Programmer’s Guide
For 6400, 5055, 59XX, 17XX, 11XX Terminals
This menu enables or disables the SST diagnostic mode.
Protocol
1) SST
2) SST-Diag Mode
3) Security ID
3) Security ID is for Proxim radios
3) Security ID (Proxim radios)
This changes the radio security identification. Enter the new security ID
(up to 16 characters) twice. If the old security ID is not correct or if the
second new security ID was not entered correctly, you will see the “un-
changed” message on the bottom line of the display.
Protocol
Security ID
New Security ID
New Security ID
If the new security ID is entered correctly, the following will appear.
Protocol
Security ID changed.
Save parms then re-
boot terminal for
change to take af-
fect.
6) Cold Start (2415, 2425, 2435A, 2455, 2475, 248X, 6400, 5020, 5055, 59XX,
17XX, 11XX)
This resets all TE values to the stored configuration in CONFIG.DAT
and performs a cold-start on the terminal. Press [Y] to reboot the terminal,
or press any other key to return to the 1) Set-up Parms menu.
Depending on the setting in the firmware menu of the terminal, after reboot-
ing, the terminal opens to the TRAKKER Antares 2400 Menu System.
Cold Start
Enter ‘Y’
to Cold Start
terminal: