Intermec CK30

Getting StartedChapter —1
4 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Performing a Quick Configuration
Note: For Terminal Emulation Version 6.60 or greater, the default data
stream is “VT/ANSI.”
1 Change the data stream to “5250.” The default data stream is “Native”
for the 6400 (WTP), 5055 (WTP), 11XX, 17XX, and 59XX Terminals.
The default data stream for 2415, 2425, 2435A, 2455, 2475, 248X,
and IP terminals is “3270.”
a Access the terminal emulation configuration menus by pressing the
following keys, then choose 1) Set-up Parms from the M ain Menu.
Terminal Key Sequence
2415
)! (55-key keyboard)
(5 (37-key keyboard)
2425
(!
2435A
rl (57-key keyboard)
Green
> ,Orange > (48-key keyboard)
rl (39-ke y function numeric keyboard)
2455, 2475, 248X
(¡
6400 [Gold] [Blue]
5055 [Blue] [M] or [ALT] [M]
59XX [Brown] [Space]
17XX, 11XX [Gold] [Black]
Note: Press a number to select a menu option, then press [Enter] to
return to a previous menu.
b At the Enter Password prompt, enter “cr52401. ”
On 17XX (37-key) T erminals, the password is: F12F1152401
c From the Set-up Parms menu, select 3) Protocol Opts,
2) Data Stream,then3) 5250.
2 Extended commands transmit or r eceive data over the terminal’s
RS-232 port, send information to an RS-232 device, or collect data. En-
able the Extended Cmds option if your host computer is configured to
send extended commands to the terminal. It is disabled by default.
From the Protocol Opts menu, select 3) Extended Cmds,then
1) Enabled.
3 From the Main M enu, select 7) More,then2) Save Parms.
4 At the Enter Password prompt, type “cr52401,” then press enter.
On 17XX (37-key) T erminals, the password is: F12F1152401
5 From the Main M enu, select 6) Exit Menus.
Note: For WTP devices, you should also set a terminal number.
6 Log in to a TE session, then use the terminal to collect/transmit data.