Intermec CK30

Using the Terminal Emulation MenusChapter —4
176 TE 2000
 5250 Terminal Emulation Programmer’s Guide
You can restart your TE 2000 application by either scanning the following
Reset Firmware bar code or by using the 6) Cold Start option in the TE
2000 configuration Main Menu. Both methods reset all terminal firmware
and the application and run the application in a new session.
Reset Firmware
*/M.*
*-.*
The terminal restarts your TE application using the configuration saved in
CONFIG.DAT, or f ollow this procedure:
1 At the third initialization screen or anywhere in a TE 2000 session, ac-
cesstheMainMenubypressingtheappropriatekeycombination(see
page 4).
COPR. 1991-2005
INTERMEC. ALL
RIGHTS RESERVED
V<version number>
<release date>
<program name> <version>
Host: <host name>
<emulation type>
TE 2000(TM)
<program name> <version>
<emulation type>
Host: <host name>
For Version 7.26 or greater
<program name> <version>
Session: <current session number>
<session name>
<emulation type>
Host: <host name>
<device name>
For Version 8.00 or greater
Note: If you are not connected to the Intermec Application Server or host,
or have problems accessing the Main Menu, reset your terminal to go to
the initialization screens.
2 Select 1) Set-up Parms, then enter the “cr52401” password. Do not press
Enter.
3 Select 6) Cold Start,press[Y] when prompted to restart, then start
using the application or change the TE configuration.
See the terminal’s user guide or manual for information on how to recover
from a lock-up condition.