Intermec CK30

Using the Terminal Emulation MenusChapter —4
104 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Controller Type
1) ITC Server
2)
3) Direct Connect
Protocol Opts
1) Host View Sze
2) Data Stream
3) Extended Cmds
4) 5250
5) 3270
6) VT220
7)
Display Opts
1)
2) Cursor Mode
3)
Cold Start
Enter “Y”
To Cold Start
terminal:
Set-up Parms
1) Menu Password
2) Print Device
3)
[1]
[3]
[4]
[7]
[6]
1) ITC Server is for
5020, 700 Series, CK30,
CK31, CV60 with TE/UDP
Plus
3) Direct Connect
is for 5020, 700 Series,
CK30, CK31, CV60 with
TE/IP
Set-up Parms
1) Communication
2) Barcode Parms
3) Protocol Opts
4) Display Opts
5)
6) Cold Start
6) Exit TE2000
7) More
[2]
[2]
Barcode Parms
1) Code 39 Encoded
2)
3) Concatenate
4)
5) Stream Scan
6) Scan All Flds
For 5020
Scan Options
1)
2) MOD 10 Check
3) Concatenate
4) BC Type Char
5) Stream Scan
6) Scan All Flds
7) More
For 700 Series, CK30, CK31, CV60
1) Backlight is for
700 Series
6) Font Quality is
for CK30, CK31
Exit TE2000
Enter “Y”
To Exit TE2000:
[6]
For 700 Series, CK30, CK31, CV60 For 5020
Display Opts
1) Backlight
2) Cursor Mode
3) Select Font
4)
5) Display Colors
6) Font Quality
7) More
[4]
For 700 Series, CK30, CK31, CV60
For 5020
6) Cold Start is for 5020.
6) Exit TE2000 is for 700 Series,
CK30, CK31, CV60.