Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
173TE 2000
 5250 Terminal Emulation Programmer’s Guide
6 Hold down the [I] key while turning on the terminal re ceiv ing the pro-
gram. The application program will copy into the receiving terminal.
To NC1100
Charger
To Receiving
Terminal
To Source
Terminal
To Source Terminal
To Receiving
Terminal
12-Volt Cable (P/N: 216-911-001)
5-Volt Cable (P/N: 216-909-001)
This illustrations shows the FLASH cloning cable connections as they pertain to step 1 on the
previous page.
To clone parameters from one terminal to another, first ensure the desired
parameters are already set in the terminal you wish to transfer from. Then:
1 Connect the terminals together using the cloning cable. Data Terminals
with 12-volt FLASH use P/N: 216-911-001. Data Terminals with
5-volt FLASH use P/N: 216-909-001.
2 With both terminals turned ON, press 3) Cloning Opts on both.
3 Onthesourceterminal(the terminal with the parameters from which to
copy),press2) Clone Parms.
4 On the receiving terminal, press 3) Receiv e Parms.Ifusingthecable
that requires the NC1100 Power Supply and Charger, make sure it is
connected to the NC1100 Power Supply and Charger.
Follow the alignment from the NC1100 power supply to the cloning cable connection. This
illustration pertains to step 1 on page 172.