Intermec CK30

Using the Terminal Emulation MenusChapter —4
100 TE 2000
 5250 Terminal Emulation Programmer’s Guide
1) Set-up Parms (2415, 2425, 2435A, 2455, 2475, 248X)
This is password-protected to prevent u nauthorized users from changing
parameters. You can customize the parameter’s CONFIG.DAT setup file
to change the password. See Chapter 5, “Customizing Your Configuration.”
Changed parameters apply to the current session. If more than one session
is available, use the 7) More > 2) Save Parms > 4) Session Menu to verify
or change the current session before going to the next session. To open the
1) Set-up Parms menu, press [1], [Enter], then type “cr52401” at the
prompt to access the following menus.
Controller Type
1) ITC Server
2) RTC/WTP
3) Direct Connect
Protocol Opts
1) Host View Sze
2) Data Stream
3) Extended Cmds
4) 5250
5) 3270
6) VT220
7) Native
Protocol
1) SST
2) SST-Diag Mode
3) Security ID
Display Opts
1) Backlight
2) Cursor Mode
3)
Cold Start
Enter “Y”
To Cold Start
terminal:
Set-up Parms
1) Menu Password
2)
3) COM Select
[1]
[3]
[5]
[4]
[7]
[6]
7) Native is blank
if UDP Plus or
TCP/IP
3) Security ID is
for Proxim radios
3) COM Select is for
248X
1) ITC Server is for
2415, 2425, 2435A, 2455,
248X with TE/UDP Plus
3) Direct Connect
is for 2415, 2425, 2435A,
2455, 2475, 248X with
TE/IP
Set-up Parms
1) Communication
2) Barcode Parms
3) Protocol Opts
4) Display Opts
5) Radio Comm
6) Cold Start
7) More
5) Radio Comm is blank for 2415,
2425, 2435A, 2455, 2475, 248X Ter-
minals without either an 802.1x sup-
plicant radio driver or UDP Plus.
2) RTC/WTP
is for 2415, 2425,
2435A, 2455, 2475,
248X with RTC
[2]
Barcode Parms
1) Code 39 Encoded
2)
3) Concatenate
4) RS232 Stream
5) Stream Scan
6) Scan All Flds