Intermec CK30

Customizing Your ConfigurationChapter —5
212 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Radio Communications Options
Set the Securi ty ID f or 2415, 2425, 2435A, 2455, 2475, 248X ter minals
without an 802.1x supplicant radio driver or UDP Plus installed through
the Trakker Antares 2400 Menu System.
Note that brackets indicate default settings and values.
Radio Communications Options
Options
[Session 1]
Session 2
Values
Terminals using this
option
Baud Rate
(UHF radio)
Radio Baud Rate 4800, 4800/9600, 9600 2415, 2425, 2435A,
2455, 2475, 248X wi th
802.1x supplicant radio
d
r
i
v
e
r
o
r
U
D
P
P
l
u
s
Note that the default depends on the type of radio in the te rminal.
d
r
i
v
er or
U
D
P
P
l
us
installed, 6400, 5055,
11XX, 17XX, 59XX
Disconnection
Value
Disconnect Val Numeric, minimum = 1,
maximum = 10 [2]
2415, 2425, 2435A,
2455, 2475, 248X wi th
UDP Plus installed
Protocol Radio Protocol These qualifiers apply to
UHF: RTC, Adaptive Poll,
6400, 5055, 11XX,
17XX, 59XX
Note the default depends on the radio type and is either
RTC or SST.
,
p
,
RTC-Diag Mode,
These qualifiers apply to
SST: SST, SST -Diag Mode
7
,
5
9
Security ID Security ID String, minimum length=0,
maximum length=16 [null
string] Default is
NORANDOWL for 6400,
5055, 59XX, 17XX, 11XX.
2415, 2425, 2435A,
2455, 2475, 248X wi th
802.1x supplicant radio
driver or UDP Plus
installed, 6400, 5055,
11XX, 17XX, 59XX
User Authe ntication User Auth Enabled, [Disabled] 2415, 2425, 2435A,
2455, 2475, 248X wi th
802.1x supplicant radio
driver installed
More Options
Note that brackets indicate default settings and values.
More Options
Options
[Session 1]
Session 2
Session 3 (700 Series, CV60)
Session 4 (700 Series, CV60)
Values
Terminals using this
option
Change Menu
Password
Change Menu Password String, minimum length =
1, maximum length = 10
[
3
1
9
3
6
9
3
]
2415, 2425, 2435A,
2455, 2475, 248X,
6
4
0
0
5
0
2
0
5
0
5
5
You must enable and set the password to access the Main
Menu before you can change it. To set the password, see
above.
g
[3193693]
To enable the password, se e
“Main Menu password.”
6400, 5020, 5055,
11XX, 17XX, 59XX,
700 Series, CK30, CV60
COM Select Com S elect [COM 1], COM 2 248X, 5055