Intermec CK30

Customizing Your ConfigurationChapter —5
220 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Set-Up Parameters Options (continued)
Terminals using this
option
Values
[Session 1]
Session 2
Session 3 (700 Series, CK30, CK31, CV60)
Session 4 (700 Series, CK30, CK31, CV60)
Options
Terminal Type host_a|terminal_type (default)
host_b|terminal_type
host_c|terminal_type
Numeric, mi nimum =
0, maximum = 255
[255]
700 Series, CK30,
CK31, CV60
Unit Number
(same as radio
numbe r)
host_a|unit_# (default)
host_b|unit_#
host_c|unit_#
Numeric, mi nimum =
0, maximum = 127
[127]
700 Series, CK30,
CK31, CV60
Bar Code Parameters
Note that brackets indicate default settings and values.
Bar Code Parameters
Parameters
[Session 1]
Session 2
Session 3 (700 Series, CK30, CK31, CV60)
Session 4 (700 Series, CK30, CK31, CV60)
Values
Terminals using this
parameter
BC Type Character bc_type_char Enabled, [Disabled] 700 Series, CK30,
CK31, CV60
Code 39 Encoded code_39_encoded Enabled, [Disabled] 700 Se ries, CK30,
CK31, CV60
Concatenate concatenate Enabled, [Disabled] 700 Series, CK30,
CK31, CV60
MOD 10 Check mod_10_ch eck Enabled, [Disabled] 700 Series, CK30,
CK31, CV60
ParmsBySession parmsbysession Enabled, [Disabled] 700 Series, CK30,
CK31, CV60
Scan All Fields scan_all_flds Enabled, [Disabled] 700 Series, CK30,
CK31, CV60
Scan Postamble
Character
scan_postchar Numeric, minimum =
0, maximum = 255
[0]
700 Series, CK30,
CK31, CV60
Scan Preamble
Character
scan_prechar Nume ric, minimum =
0, maximum = 255
[0]
700 Series, CK30,
CK31, CV60
Scanner Type scanner_type [No Scanner], Wand,
Laser, Wand Emulate,
Auto Detect
700 Series, CK30,
CK31, CV60
Stream Scan stream_scan Enabled, [Disabled] 700 Series, CK30,
CK31, CV60
Use Wedge Mode use_wedge_mode [Enabled], Disabled 700 Series, CK30,
CK31, CV60