Getting StartedChapter —1
6 TE 2000
5250 Terminal Emulation Programmer’s Guide
The TE 2000 application does not support the following 5250 commands:
Alternate cursor Allows selection of either the bar-type or block-type cursor.
Display cursor location Displays the cursor location.
Display Mode Allows the operator to adjust the display to h is or her pre -
ference. To adjust the terminal’s display, refer to the termi-
nal’s user manual.
Test Request Accesses diagnostic routines.
Also note that Trakker Antares terminals with UDP Plus or TCP allow
only one session per terminal. Dual sessions are not supported.
To Next Page
Loading...
