Display Data Stream—Chapter 6
297TE 2000
5250 Terminal Emulation Programmer’s Guide
The parameter error s are a subset of the 5250 data stream command set.
Those errors supported by the terminals are listed in below.
Parameter
Error
Description
P21 Premature end of data stre am.
P22 A row or colu mn specification is out of range.
P23 The ending address of the Repeat to Address order is less than the start
address.
P25 Asignedinputfieldhadalengthof1.Itmustbeatleast2.
P26 An input field start address was less than a previou sly-defined input field
start address.
P27 An invalid Restore Screen command was received.
P28 An attempt w as made to define an input field past the e nd of the display.
P29 Format table overflow (too many inpu t fields were defined).
P2A An attempt was made to w rite data past the e nd of the display.
P2C Invalid roll up or roll down parameters were received.
P30 An invalid attribute was received as part of a SF order.
P87 A MOD 10 or MOD 1 1 input fie ld was defined with a length greater
than 33.
To Next Page
Loading...
