Intermec CK30

Extended Commands—Chapter 7
301TE 2000
 5250 Terminal Emulation Programmer’s Guide
Thefollowingtabledescribesthelineandcolumnswherecharactersmust
appear, and their meanings. Note that “b”indicatesa1-bytespace.
Transmit and Receive Characters — Line 1, Columns 2–24
Column Description Character
2 Extended command #
3 Transmit and Receive on RS-232 Port command F
4 S peed (bits per se cond) 1=1200; 2=2400; 3=4800; 4=9600; 5=19200;
6=38400
5 Data parity N=None; 0 (zero)=None; b=None; E=Even; O=Odd
6 Data bits 7=S even; 8=Eight
7 Stop bits 1=One; 2=Two
8 For 6400, 5055, 59XX, 17XX, 11XX:
CTS flow control
For 2 415, 2425, 2435A, 2455, 2475, 248X, 5020,
700 Series: Reserved
0=Disable; 1=Enable
b
9 For 5055, 59XX, 17XX, 11XX: DTR flow control
For 2 415, 2425, 2435A, 2455, 2475, 248X, 6400,
5020, 700 Series: Reserved
0=Disable; 1=Enable
b
10 XON/XOFF flow control 0=Disable; 1=Enable
11–12 Flow control timeout value XX=Number of seconds
13 Retu rn AID key b=AID key is E nter (default).
X=AID key ch aracter. See the “Return AID Keys”
tableonpage303forreturnAIDkeycharacters.
14–15 Maximum characters to receive bb=Default
dd or XddX, where: dd=00–99. Defa ult: 99.
dd=Any number of decimal digits from 0–2000,
inclusive. Default: 99.
16–17 Delimiter character AA=Hexadecimal ASCII code that marks the end of
data to be received. Range: 00-7E. De fault of 00 or
bb
implies no start character.
18–19 Number of delimiter charac ters XX=Number of characters acce pted before sending
return code to host. Range: 00–99. De fault of 00 or
bb
implies no start character.
20–21 Start character AA=Hexadecimal ASCII code. Range : 00–99. De -
fault of 00 or bb
implies no start character.
22 Return start character to host F=Return ch aracter
b
=Do not return character
23 Flag parity errors P=Flag
b
=Do not flag
24–25 Receive timeout length XX=Number of se conds the terminal waits for input
from the RS-232 port before it sends a timeout er-
ror. Uses the 5-second default when field contains
spaces.