Intermec CK30

Using Terminal Emulation Applications—Chapter 2
11TE 2000
 5250 Terminal Emulation Programmer’s Guide
To disable Auto Tab Scan:
1 Configure the Auto Tab Scan setting to Disable. For help, see Chapter
4, “Using the Terminal Emulation Menus.”
With the Auto Tab Scan feature disabled, the terminal functions as if
the field has a mandatory field exit turned on (an AS/400 activated fea-
ture known as Check FE). As a result, legacy AS/400 applications do
not have to be modified to turn this field on properly for bar code sup-
port. The default is Auto Tab Scan disabled.
2 Save your new TE configuration.
To add Field Exit to the postamble via Trakker Antares 2500 Menu System:
1 Access the TRAKKER Antares 2400 M enu System. For help, refer to
your terminal’s user manual.
2 From the Main Menu, choose Configuration Menu > Terminal Menu
> Preamble/Postamble.
3 Move the cursor to the postamble field.
4 Type \x9A for the literal Field Exit code.
5 Press ; or choose OK to save your changes and exit the screen.
6 Exit the TRAKKER Antares 2400 Menu System and save your new
configuration to f lash memor y. For help, refer to your terminal’s user
manual.
To download Field Exit as a postamble from the Intermec Application Server:
ConfigurethepostambletotheFieldExit’sliteralvalueusingthedown-
load server on the Intermec Application Server. Use the download server
on the Intermec Application Server:to configure one or more terminals in
the network.
1 In the download server on the Intermec Application Server: select the
terminal or group to receive the Postamble (AE) configuration com-
mand. For help on configuring a group of terminals, refer to the Inter-
mec Application Server U ser’s Guide (P/N: 072242).
You can continue running the 5250 TE application on the terminal
while configuring a terminal from the Intermec Application Server.
2 Choose the option to enter a command.
3 Type the string $+AE and then enter the ASCII code 154 by holding
down the Alt key while typing 154 on the numeric keypad. You should
see an Ü to represent the literal Field Exit code in the edit box, which
now shows this command and value: $+AEÜ
4 Download the commands to change the runtime configuration of the
terminals selected. The changes are saved in RAM, but not in flash
memory.
5 To save the configuration change in flash memory, download this
command: .+1
You can also use the TRAKKER Antares 2400 Menu System to save the
configuration in flash memory. Refer to the terminal’s user manual.