Intermec CK30 - Page 435

Index
411TE 2000
 5250 Terminal Emulation Programmer’s Guide
Main menu, 99
2415, 2425, 2435A, 2455, 2475, 248X, 99
5020, 700 Series, CK30, CV60, 103
5055, 179
6400, 177
6400, 5055, 59XX, 17XX, 11XX, 101
opening, 98, 99
bar code label, 361
options, 98
password
CONFIG.DAT option, 213
TE_SETTINGS.INI option, 229
Main menu 2, 171
cloning opts, 172
keyboard opts, 171
Save parms, 171
session menu, 174
copy setup, 174
session name, 174
set hot key, 174
switch, 174
Mandatory entry field, 286, 289, 296
Mandatory fill field, 286, 289, 296
Maximum bar code length
CONFIG.DAT option, 204
TE_SETTINGS.INI option, 223
MC (Move Cursor) order, 282
MDT bit
Clear Format Table command, 271
Clear Unit command, 272
Read Immediate command, 260
Read Input Fields command, 262
Read MDT Alternate command, 266
Read MDT Fields command, 264
Restore Screen command, 273
Start of Field order, 286
Write to Display command, 278
Memory, reprogramming flash , 252
Memory view te st, 168
Menu password, 143
Menu settings, 156
Menus, opening, 98, 99, 361
Message, display annunciators
11XX, 92
17XX, 92
5055, 92
59XX, 92
6400, 92
Message Waiting annunciator, 10
Clear Format Table command, 271
Clear Unit command, 272
Restore Screen command, 273
Signal command format, 295
Write to Display command, 278
Messages, system, 296
Microsoft ActiveSync, 187, 188, 251
Minimum bar code length
CONFIG.DAT option, 204
TE_SETTINGS.INI option, 224
“Missing ‘;’ ” message, 196
“Missing ‘=’ ” message, 196
Mod 10 c h eck, 116
CONFIG.DAT option, 199, 208
parameter code for, 297
Start of Field order, 289
system code for, 296
TE_SETTINGS.INI option, 220, 226
Mod 11 check
CONFIG.DAT option, 208
parameter code for, 297
Start of Field order, 289
system code for, 296
TE_SETTINGS.INI option, 226
Mode , CONFIG.DAT option, 197
Modified data tag bit. See MDT bit
Modified field, 286, 289
Move Cursor order, 282
MSI Plessey, 373
MSR, 287, 288, 290
N
Native, 123, 134
programmer’s guide, xxiv
NC1100 Power Supply and Charge r, 173
Negative response, 278
Network, 2
New Line key
11XX, 62
17XX, 57
2415, 21
2425, 24
2435A, 29
2455, 33
2475, 36
248X, 36
5020, 44
5055, 49
59XX, 53
6400, 40
700 series, 67, 69
bar code label, 360
CK30, 75
CK31, 80
CV60, 86
description, 15
No UCC Type
CONFIG.DAT option, 208
TE_SETTINGS.INI option, 227
Nonbypas s field, 286
Norand Utilities, 253
Norwegian ch aracte r se t, 247
Norwegian IBM character set, 248