PLDC01938
REVISION 00
01/06/2011
TECHNICAL DEPT.
Stavale
- date 05/09/2011
93/195
11
Disconnect the connectors E3 and E4 of the actuator E and remove it from its support for testing on the
bench.
Reassembly
1
Before replacing the electromechanical actuator E, test it on the bench as described in the following
paragraph.
2
If the actuator requires replacing with a new one, check that the data given on the adhesive rating
plate correspond, paying particular attention to the voltage, travel and maximum lifting force.
3
To mount the new actuator, perform the disassembly operations in reverse.
E3
E4
E4
E3
PHOTO 199
To Next Page
Loading...
