PLDC01938
REVISION 00
01/06/2011
TECHNICAL DEPT.
Stavale
- date 05/09/2011
47/195
11
First unscrew one of the two screws F1 per side.
12
Then unscrew the other two screws F1, taking care not to damage the thread on the chassis. To avoid this,
you should keep the head raised until the last screw F1 has been removed.
13
Rest the head on the surface and push it forwards to release the actuator rod and free it from the detergent
pump G.
14
Paying attention to the detergent pump G, remove the head from beneath the machine from the right side.
Reassembly
1
To remount the head, perform the disassembly operations in reverse.
2
Screw up the screws F1 with a maximum torque of 45 Nm (~ 4.5 kgm).
F1
PHOTO 105
F
G
PHOTO 106
To Next Page
Loading...
