Jabiru j430 - Fin; Horizontal Stabiliser

Aircraft Technical Manual
Jabiru Aircraft Pty Ltd
JTM001-5
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
ISSUE
1
2
3
4
5
Dated: 29th October 2014
Issued By: AS
Page: 108 of 298
6.24 Fin (all J-Series)
 The Fin is a moulded composite structure supported by ribs and a rear spar. Hinges attach the rear
spar to the rudder.
6.24.1 Removal, Installation, Inspection And Repair
 The fin is an integral part of the fuselage structure and cannot be removed.
 All repairs must be referred to Jabiru Aircraft Pty Ltd or our approved local agent.
6.25 Horizontal Stabiliser (all J-Series)
 The horizontal stabiliser is a moulded stressed-skin structure of rigid cellular polystyrene bonded to a
fibreglass skin and rear spar.
6.25.1 Removal And Installation
 The horizontal stabiliser is an integral part of the fuselage to which it is bonded. It cannot be
removed.
 All repairs must be referred to Jabiru Aircraft Pty Ltd or our approved local representative.