Jabiru j430 - Equipment; General

Aircraft Technical Manual
Jabiru Aircraft Pty Ltd
JTM001-5
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
ISSUE
1
2
3
4
5
Dated: 29th October 2014
Issued By: AS
Page: 31 of 298
3.7 Equipment:
Access to the following equipment will be required:
 Bench vice with padded jaws
 Calipers: must read up to 180mm
 Degreasing/cleaning system with solvent/solution containment/recycling
 Hand press
 Heat gun or small butane/propane torch with a soft pencil flame
 Multimeter or an ohmmeter
 Imperial thread taps: UNF and UNC
 Adjustable wing stands
 Saw-horses
 Fuel-proof container with accurate volume markings
 Soldering iron
 Cable ties
 An accurate tyre pressure gauge
 Accurate scales and spirit level if the aircraft is to be weighed.
3.8 General:
 Brass drifts, punches, rags, soft mallet, hammers
 Greases: molybdenum disulphide, general purpose
 TorqueSeal brand security marking lacquer or similar, such as coloured nail varnish
 5-Minute epoxy resin, Jabiru epoxy resin, cotton fibre flock, Q-cells (micro-balloons), containers,
scales, mixers etc.
 Scratch-removing compounds such as Novus Plastic Polish for windows.