CUTTING UNITS
4222983 Second Edition 6-19
6
Figure 6-10
5. Tighten adjuster nut (8) until the spring (9)is
completely collapsed, then back the nut 2–3 turns, or
until there is 0.040 in. (1.27 mm) side-to-side
movement of the reel.
Figure 6-11
6. Install spacer (10), washer (11), lock washer (13),
and screw (12).
Figure 6-12
7. Install counterweight (14), screws (15), and lock
washers (16).
8. Adjust bedknife-to-reel contact. (See
“Bedknife-to-Reel Clearance Adjustment” on
page 6-16.)
TN2652
9
8
TN2653
10
12
11
13
TN2650
14
15 16
15 16
To Next Page
Loading...
