3 – 62
3
3.4.1 Overview
The "Radar function setting" enables users to constantly obtain the optimum radar video by storing the
settings of complicated radar signal processing functions in the optimum state for each purpose and calling
the required setting according to the use condition.
The contents are set when the radar is delivered from the factory according to the general usage condition.
The setting contents can be adjusted in detail through menu operations.
The following four function modes can be used. The modes are set as follows at delivery from the factory.
Function 1 : COAST
Function 2 : DEEP SEA
Function 3 : BUOY
Function 4 : STORM
Note
● When a function mode is used, you cannot use the Performance Monitor.
If you want to use the Performance Monitor, set function mode "OFF" by pressing
FUNC
key.
3.4.2 Operation Method
(1) Calling a function
• Whenever the
FUNC
key is pressed, the function is switched in the order of Function Off ➝
Function 1 ➝ Function 2 ➝ Function 3 ➝ Function 4 ➝ Function Off.
• The name of the function mode that is currently being called is displayed on the top-left corner of the
screen.
(2) Changing a Setting (Temporary Change)
• When the setting of the radar signal processing is changed using the MAIN MENU or SUB MENU
while one of the functions from Function 1 to Function 4 is called, the change is reflected in the
operation state temporarily.
• However, since the stored contents are not changed, the change is cancelled as soon as some other
function setting is called. (When the function setting is called again, the operation is set according to
the stored contents.)
(3) Changing a Setting (Changing the Stored Contents)
•
When changing the stored contents of one of the functions from Function 1 to Function 4, press the
SUB
MENU
,
9
,
4
keys to open the SET FUNC menu and select a required function number.
• The function setting items cover five pages and the pages can be scrolled by using the
0
and
9
keys.
• To store the current operation status in the function number, select "6. SAVE PRESENT STATE" of
the function setting item page 1. Use this function when a required setting is found and the status is
to be stored.
• To reset the stored contents to the status set at factory delivery, select "6. INITIALIZE" of the function
setting item page 5. Use this function when the function changes that were made are too complicated
to return to the original state.
3.4 Using Function Key [Func]
To Next Page
Loading...
Need help?
General
