5
5.3
5 – 10
5.3.2 Manual Acquisition
When the target which is being tracked has already reached the maximum number of targets and then
is manually acquired, the distant target which is becoming more distant from the own ship at the rear
is erased.
Procedures
Align the + cursor mark to the target to be acquired and press the
ACQ
key.
The [ ] mark is appended to the target and a vector is displayed within one minute.
Use both mode
When using automatic acquisition and manual acquisition at the same time, a target to which special attention
is to be paid is manually acquired and other targets are automatically acquired. When a new target is entered
exceeding the maximum number of targets, the manually acquired target is erased from the target which is
becoming more distant from the own ship at the rear if the automatically acquired target is not available. The
automatically acquired target is erased sequentially from the rear one. Great advantages are to be able to
maintain the manual acquisition function and to automatically acquired a new target, thereby eliminating
the need for manually acquired it.
5.3.3 Setting ／ Deleting a Target Number
This function sets ／ deletes a number to ／ from the target which is being tracked.
Setting a target number
Procedures
1. Press the
TGT
DATA
key.
2. Align the + cursor to the target to which a number is to be assigned and
press the
0
to
9
keys, then press the
ENT
key.
The number which was set near a target is displayed.
Note
● When a number which had already been used was specified, an error occurs.
After deleting the number used, set a new number again.
Deleting a target number
Procedures
1. Press the
TGT
DATA
key.
2. Align the + cursor to the target from which a number is deleted and press
the
CLR
key.
Otherwise, press the
0
to
9
keys and specify a number, then
press the
CLR
key.
Attention
To Next Page
Loading...
Need help?
General
