III
●
Cautions to be Used During Operation
●
WARNING
Do not touch the insides of the scanner, transceiver and dis-
play unit.
Touching any high voltage area, you will get an electric shock. For maintenance,
inspection and adjustment of internal parts of these equipment, consult with our sales
office or distributor in your district.
Since the scanner radiator rotates, do not approach it.
The scanner may start rotating suddenly, and consequently any person may be struck
and be injured. We recommend you to install the scanner radiator on the roof of the
wheel house, flying bridge, trestle, radar mast or any other high position so that no
person can approach it. When servicing the scanner, set the scanner safety button to
the OFF position.
Install the scanner at any place higher than any person.
If being exposed directly to electric wave at close range, you may suffer adverse
influence.
When approaching the antenna for maintenance or inspec-
tion, set the power button of the display unit to the ST-BY
position.
If being exposed directly to electric wave at close range, you may suffer adverse
influence.
CAUTION
Use these radar only as assisting devices for navigation.
Also, the officer should make the final decision for maneu-
vering by himself.
Use ATA only as an assisting device for navigation.
Also, the officer should make the final decision for maneu-
vering by himself.
ATA's information such as vector, target value data, alarm, etc. may contain some
errors. Also, targets which cannot be detected with these radar cannot be tracked at
their acquisition points.
To Next Page
Loading...
Need help?
General
