5.10
5 – 37
5.10.7 Erasing the Storage of Target Past Track by Specifying
a Number
This setting is valid when target past track function is ON.
This function erases the storage of target past track with the specified target past track number.
The erased target past track is not reproduced.
Erasing target past track
Procedures
1. Press the
SUB
MENU
key to open the SUB MENU.
2. Press the
7
key to open the ATA TRACK menu.
3. Press the
9
key to open the CLR TRACK menu.
4. Press the
2
key to select "CLEAR TRACK NUMBER".
5. Press the
2
key to select the confirmation display of erase.
6. When pressing the
ENT
key , the confirmation display of erase will
appear.
7. Press the
ENT
key to erase the storage of target past track.
Exit
8. Press the
SUB
MENU
key to close the CLR TRACK menu.
Canceling erase
Press the
CLR
key instead of the
ENT
key in the operation procedure
7 for erasing target past track to stop the erase of target past track.
CLR TRACK
1. CLEAR TRACK COLOR ALL WHT SKY BLU GRN YEL PNK RED
2. CLEAR TRACK NUMBER ALL 0 1 2 3 4 56789OTHER
3. CARD 2 TRACK DISP 0
Attention
CLR TRACK 0. PREV
To Next Page
Loading...
Need help?
General
