JRC JMA-7710-6 - Suppressing Sea Clutter [SEA]

3
3 – 6
3.2
3.2.4 Suppressing Sea Clutter [SEA]
AUTO
SEA
This control is used to suppress sea clutter. Although turning it clockwise increases the suppressing effect,
excessive suppressing could miss weak target at short range.
To use Auto Suppressing Sea Clutter mode
Procedures
Procedures
1. Adjust the
AUTO
SEA
so that the target is displayed most clearly.
2. Press the
AUTO
SEA
control.
Select auto suppressing sea clutter mode, then "STC AUTO" appears on upper right of
the screen. Turn the control again when the target is not displayed most clearly.
Exit
Exit
3. Press the
AUTO
SEA
control again.
"STC AUTO" disappears on the upper right of the screen, changes to manual mode.
Note
● Auto suppressing sea clutter mode can not select with auto suppressing rain and snow clutter mode.