JRC JMA-7710-6 - Page 149

3
3 – 90
3.7
1. Press the
SUB
MENU
,
4
,
9
, and
4
keys in this order to open
the NAV INFO menu.
2. Press the
1
key to select "SETTING WPT/CANCELLATION WPT".
3. Press the
ENT
key.
The menu will disappear and the destination number will be displayed on the screen.
4. Move the cursor to the destination number mark and press the
CLR
key.
NAV INFO
1. SETTING WPT ／ CANCELLATION WPT
2. WAYPOINT INPUT LAT ／ LON COMMENT
00 N 0° 00.000' XXXXXXXXXX
E0° 00.000' XXXXXXXXXX
ＡＢＣＤＥＦＧＨＩＪＫＬＭＮＯＰＱＲＳＴＵＶＷＸＹＺ
ａｂｃｄｅｆｇｈｉｊｋｌｍｎｏｐｑｒｓｔｕｖｗｘｙｚ
０１２３４５６７８９ ＋−，．＃（）￥＠＊；／
Caution : When the destination is used for setting a navigation line, a message of "Currently Used" will
be displayed and it cannot be deleted.
To input comments for the destination
- Comments can be input using alphabet characters, numerals, and special characters.
- A total of 20 characters can be input in two lines with each 10 charters per line.
- Input the number of geodetic datum using the first two characters. (Refer to the list of geodetic data on
page 8-37.)
- Input an arbitrary name for identification using the third and succeeding characters.
Procedures
Procedures
1. Press the
SUB
MENU
,
4
,
9
, and
4
keys in this order to open
the NAV INFO menu.
2. Press the
2
key to select "WAYPOINT INPUT", press the minus (-)
side of the
RANGE
key or plus (+) side of the
RANGE
key to select the
destination number that was input on the destination input item, and press
the
ENT
or
2
key to move to the input item.
NAV INFO 0. PREV
9. NEXT