- IV -
WARNING
Never directly touch the internal components of the scanner or
indicator. Diect contact with these high-voltage components may
cause electric shock. For maintenace, inspection, or adjustment of
equipment components, consult with our branch office, branch shop,
sales office, or our distributor in your district.
To contact our sales department, branch offices, branch shops, and
sales offecs:
Prese refer to the “Office List” at the end of the document.
Do not get close to the radiant section of the scanner. It is a rotating
part, and it may cause injuries if it suddenly starts rotating and
consequently hits the body. It is recommended that the radiant section
be installed at a high place such as on the roof of the wheelhouse, on
the flying bride, on the trestle, or on the radar mast so that no one can
get close to it. When any work must be done on the scanner, make
sure to turn the safery switch off.
Microwave rediation level:
Keep out from a distance closer than that specified below for each
type of scanner when it is transmitting. Being within the specified
distance from the center of the front face of the scanner may cause
imicrowave exposure which could result in injuries (especially of the
eyes).
NKE-1125/1129 (radiation levels: 10 W/m
2
): 0.7m
NKE-1130/1139 (radiation levels: 10 W/m
2
): 1.1m
Make sure to install the scanner at a place higher than human height.
Direct exposure to electromagnetic wave at close range will have
adverse effects on the human body.
When it is necessary to get close to the scanner for maintenance or
inspection purposes, make sure to turn the indicator power switch to
“OFF”or “STBY”.
Direct exposure to electromagnetic waves at close range will have
adverse effects on the human body.
To Next Page
Loading...
Need help?
General
