3-5
WARNING
3.1.5 End the Operation and Stop the System
Exit 1 Press [TX/STBY] key.
The radar will stop transmission and the antenna will stop rotating.
Transmit at the upper left of the radar display changes to Standby .
Maintain the standby state if radar observation is restarted in a relatively short time.
Only pressing the [TX/STBY] key starts observation.
2 Press the [POWER] key.
The system will be turned off.
When conducting maintenance work, make sure to turn
off the power and make the main breaker OFF so that
the power supply to the equipment is completely cut
off.
Some equipment components can carry electrical
current even after the power switch is turned off, and
conducting maintenance work may result in electric
shock, equipment failure, or accidents.
When turning off the power of the unit, press【POWER】
switch once shortly.
Then shut down progresses, and the power will be
turned off.
If keeping pressing【POWER】switch, there is a
possibility of trouble due to abnormal shut down.
To Next Page
Loading...
Need help?
General
