5-30
5.3 AIS Operation
yy
yyy
5
z When the AIS function is set to Off, the AIS display
function is turned off and AIS symbols are no longer
displayed.
z Once the AIS display function is set to Off, it is not
automatically switched to On even if a dangerous
target exists.
5.3 AIS OPERATION
5.3.1 Restrictions
The following restrictions are placed on use of the AIS function.
• The AIS function is unavailable in the following cases:
MAN or REF TGT is selected for the speed sensor.
The current offset (Set/Drift Setting) is set while LOG or 2AXW is selected for the speed sensor.
• LOG or 2AXW cannot be selected for the speed sensor in the following case:
The AIS function is turned on and the current offset (Set/Drift Setting) is selected.
• MAN cannot be selected for the speed sensor in the following case:
The AIS function is On.
• Current offset (Set/Drift Setting) cannot be turned on in the following case:
LOG or 2AXW is selected for the speed sensor while the AIS function is on.
5.3.2 Setting AIS Display Function (AIS Function)
Procedures 1 Press [AIS/TT] key, or put the cursor on the AIS button located at the
upper right of the display and left-click.
The received AIS information will be shown on the radar display.
Attention
To Next Page
Loading...
