3-75
[4] Setting target symbol brilliance (TGT)
The brilliance of the target symbol on the radar display is adjusted.
Procedures 1 Left-click the TGT button located at the lower right of the radar
display, and adjust the brilliance of the target symbol so as to get the
best view of the video display.
The brilliance of the target symbol can be adjusted on four stages without opening the
Brilliance Setting menu.
Adjust the radar display to obtain the best-to-view video.
3.8.9 Adjust Sound Volume (Buzzer Volume)
When an alarm is activated, the operation panel issues an alarm audible to inform user of the change of
the condition.
The alarm sound can be adjusted by performing the following procedures.
Procedures 1 Open the Buzzer Volume menu by performing the menu operation
below.
Main Menu
→ Sub Menu
→ Buzzer Volume
Display Buzzer Volume menu will appear.
･ The volume of the alarm sound can be specified for each cause for alarm.
･ Level6 indicates maximum volume and Level0 indicates minimum volume.
However, the minimum volume of the dangerous ship alarm is level 1
Key ACK : The operation key acknowledgement is set.
OPE Miss : The incorrect operation alarm is set.
CPA / TCPA Alarm : The dangerous ship alarm is set.
New Target Alarm : The automatic acquisition target alarm is set.
Lost Alarm : The target lost alarm is set.
Navigation Alarm : The navigation data abnormality alarm is set.
System Alarm : The system abnormality alarm is set.
Inter Switch : The inter switch switching alarm is set.
Alarm mane
Slide bar of
volume adjustment
To Next Page
Loading...
Need help?
General
