5-41
z Turn off Association in order not to make a
decision on if targets are identical, or in order to
display symbols that have disappeared.
5.4 DECISION OF TARGETS AS IDENTICAL
(Association)
Setting of Function to Decide Targets as Identical (Association)
When an AIS target and a tracking target are decided to be identical, an association symbol is displayed for the
targets regarded as identical. In this case, the AIS target symbol is automatically activated.
Procedures 1 Left-click the Association in Target Information located at the upper
right of the display.
Association will be set to on or off.
Setting of Conditions for Identical (Association Setting)
Procedures 1 Open the Association Setting menu by performing the following menu
operation.
AIS
→ Association Setting
The Association Setting menu will appear.
2 Select and enter the item to be set.
Conditions for deciding targets as identical will be set. When targets are under the set
conditions, they are regarded as identical.
When targets are 125% over the set conditions, they are regarded as dissidence.
* The setting for this function is common to Association Setting in the AIS Menu.
Attention
To Next Page
Loading...
