CHAPTER 16
Connecting the MX5, MX10, MX40, and
MX80 Routers to the Network
•
Tools and Parts Required for MX5, MX10, MX40, and MX80 Router
Connections on page 97
•
Connecting MX5, MX10, MX40, and MX80 Routers to Management Devices on page 97
•
Connecting Interface Cables to MX5, MX10, MX40, and MX80 Routers on page 99
Tools and Parts Required for MX5, MX10, MX40, and MX80 Router Connections
To connect the router to management devices and line cards, no tools or parts are
required.
Related
Documentation
Installing the MX5, MX10, MX40, and MX80 Cable Management Bracket on page 79•
• Connecting MX5, MX10, MX40, and MX80 Routers to Management Devices on page 97
• Connecting Interface Cables to MX5, MX10, MX40, and MX80 Routers on page 99
Connecting MX5, MX10, MX40, and MX80 Routers to Management Devices
•
Connecting the Router to a Network for Out-of-Band Management on page 97
•
Connecting the Router to a Management Console or Auxiliary Device on page 98
Connecting the Router to a Network for Out-of-Band Management
To connect to the ETHERNET port on the Routing Engine:
1. Turn off the power to the management device.
2. Plug one end of the Ethernet cable (Figure 37 on page 98 shows the connector) into
the ETHERNET port on the Routing Engine. Figure 38 on page 98 shows the port.
3. Plug the other end of the cable into the network device.
97Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
