Related
Documentation
MX5, MX10, MX40, and MX80 Cooling System Description on page 19•
• Maintaining the MX5, MX10, MX40, and MX80 Fan Tray on page 158
• Replacing an MX5, MX10, MX40, and MX80 Fan Tray on page 111
• show chassis fan
• show chassis alarms
• show chassis temperature-thresholds
Troubleshooting the MX5, MX10, MX40, and MX80 MICs
Problem Description: The MICs are not functioning normally.
Solution Check the status of each port on a MIC by looking at the LED located on the MIC
faceplate. For information about the meaning of LED states on different MICs, see the
MX Series Interface Module Reference.
•
• Check the status of a MIC by issuing the show chassis fpc pic-status CLI command. The
MIC slots in the MX5, MX10, MX40, and modular MX80 router are labeled 1/MIC 0 and
1/MIC 1. The fixed MIC is labeled 0/MIC 0.
user@host> show chassis fpc pic-status
Slot 0 Online
PIC 0 Online 4x 10GE XFP
PIC 2 Online 1x 10GE XFP
PIC 3 Online 1x 10GE XFP
Slot 1 Online
PIC 0 Online 1x 10GE XFP
PIC 1 Online 1x 10GE XFP
PIC 2 Online 1x 10GE XFP
PIC 3 Online 1x 10GE XFP
For further description of the output from the command, see the CLI Explorer.
Related
Documentation
MX5, MX10, MX40, and MX80 Modular Interface Card Description on page 23•
• Maintaining the MX5, MX10, MX40, and MX80 MICs on page 159
• Replacing an MX5, MX10, MX40, and MX80 MIC on page 118
• show chassis fpc
Troubleshooting the MX5, MX10, MX40, and MX80 Power Supplies
Problem Description: The power supply is not functioning normally.
Copyright © 2017, Juniper Networks, Inc.170
MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
