Juniper MX10 - Installing an MX5, MX10, MX40, and MX80 DC Power Supply

The normal functioning status LED confirms that the MIC is online. You can also verify
correct MIC functioning by issuing the show chassis fpc pic-status command described
in “Maintaining the MX5, MX10, MX40, and MX80 MICs” on page 159.
Figure 51: Installing a Dual-Wide MIC
g005032
Related
Documentation
MX5, MX10, MX40, and MX80 Modular Interface Card Description on page 23•
• Maintaining the MX5, MX10, MX40, and MX80 MICs on page 159
• Troubleshooting the MX5, MX10, MX40, and MX80 MICs on page 170
• Removing an MX5, MX10, MX40, and MX80 MIC on page 119
• Preventing ElectrostaticDischarge Damage to an MX5, MX10, MX40, and MX80 Router
on page 194
• request chassis mic
• show chassis fpc
Replacing an MX5, MX10, MX40, and MX80 MIC
•
Removing an MX5, MX10, MX40, and MX80 MIC on page 119
•
Installing an MX5, MX10, MX40, and MX80 MIC on page 121
•
Installing an MX10, MX40, MX80, and MX104 Dual-Wide MIC on page 123
Copyright © 2017, Juniper Networks, Inc.118
MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide