power supply or a blank panel. If you remove a power supply, you must install
a replacement power supply or a blank panel shortly after the removal.
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on.
To remove an AC power supply (see Figure 60 on page 137):
1. Switch off the dedicated customer site circuit breaker for the power supply, and
remove the power cord from the AC power source. Follow the instructions for your
site.
2. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
3. Move the AC input switch next to the appliance inlet on the power supply to the off
(O) position.
4. Remove the power cord from the power supply.
5. Press the release latch on the left side of the power supply to disconnect the power
supply from the chassis.
6. Pull the power supply straight out of the chassis.
Figure 60: Removing an AC Power Supply
137Copyright © 2017, Juniper Networks, Inc.
Chapter 20: Replacing Power System Components
To Next Page
Loading...
Need help?
General
