CHAPTER 12
Unpacking the MX5, MX10, MX40, and
MX80 Routers
•
Tools and Parts Required to Unpack MX5, MX10, MX40, and MX80 Routers on page 75
•
Unpacking MX5, MX10, MX40, and MX80 Routers on page 75
•
Verifying the MX5, MX10, MX40, and MX80 Routers Parts Received on page 76
Tools and Parts Required to Unpack MX5, MX10, MX40, and MX80 Routers
To unpack the router and prepare for installation, you need the following tools:
•
Blank panels to cover any slots not occupied by a component
Related
Documentation
MX5, MX10, MX40, and MX80 Site Preparation Checklist on page 44•
• MX5, MX10, MX40, and MX80 Installation Summary on page 50
• Unpacking MX5, MX10, MX40, and MX80 Routers on page 75
• Verifying the MX5, MX10, MX40, and MX80 Routers Parts Received on page 76
Unpacking MX5, MX10, MX40, and MX80 Routers
The router is shipped in a cardboard carton and secured with foam packing material. The
carton also contains an accessory box and quick start instructions.
NOTE: The router is maximally protected inside the shipping carton. Do not
unpack it until you are ready to begin installation.
To unpack the router:
1. Move the shipping carton to a staging area as close to the installation site as possible,
but where you have enough room to remove the router.
2. Position the carton so that the arrows are pointing up.
75Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
