3. Open the top flaps on the shipping carton.
4. Remove the accessory box, and verify the contents against the parts inventory on the
label attached to the carton.
5. Pull out the packing material holding the router in place.
6. Verify the contents of the carton against the packing list included with the router.
7. Save the shipping carton and packing materials in case you later need to move or ship
the router.
Related
Documentation
MX5, MX10, MX40, and MX80 Site Preparation Checklist on page 44•
• MX5, MX10, MX40, and MX80 Installation Summary on page 50
• Tools and Parts Required to Unpack MX5, MX10, MX40, and MX80 Routers on page 75
• Verifying the MX5, MX10, MX40, and MX80 Routers Parts Received on page 76
Verifying the MX5, MX10, MX40, and MX80 Routers Parts Received
A packing list is included in each shipment. Check the parts in the shipment against the
items on the packing list. The packing list specifies the part numbers and descriptions of
each part in your order.
If any part is missing, contact a customer service representative.
A fully configured router contains the router chassis with installed components, listed in
Table 38 on page 76, and an accessory box, which contains the parts listed in
Table 39 on page 77. The parts shipped with your router can vary depending on the
configuration you ordered.
Table 38: Parts List for a Fully Configured Router
QuantityComponent
1Chassis
1Air filter
Up to 2MICs (modular chassis only)
1 or 2DC power supplies
1 or 2AC power supplies
1Fan tray
Copyright © 2017, Juniper Networks, Inc.76
MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
Need help?
General
