N9030B PXA Signal Analyzer Service Guide 41
Overview
Service Equipment You Will Need
3.5 mm (m) to 3.5 mm (m)
(2 Required)
Frequency: DC to 26.5 GHz
VSWR: ≤ 1.12:1
83059A 1250-1748 P
3.5 mm (f) to 2.4 mm (f)
(for 2.4 mm source)
Frequency: DC to 26.5 GHz
VSWR: ≤ 1.05:1
11901B
2.4 mm (f) to 3.5 mm (m) Frequency: DC to 26.5 GHz
VSWR: ≤ 1.05:1
11901D A, P
Type-N (f) to 2.4 mm (f)
(for 2.4 mm source)
Frequency: DC to 18 GHz
VSWR: ≤ 1.08:1
11903B A, P
Type-N (f) to 2.4 mm (f)
(for 2.4 mm source)
Frequency: DC to 18 GHz
VSWR: 1.08:1
11903D P
BNC (m) to SMA(f) Frequency: DC to 1.3 GHz
VSWR: ≤ 1.13:1
1250-1700 P
BNC Tee (BNC f,m,f) 1250-0781 A, P
BNC (f) to SMA (m) Frequency: DC to 1.3 GHz 1250-1200 A, P
BNC (f) to Dual Banana 1251-2277 A, P
3.5 mm (f) to Type-N (m) Shipped with the 8485A for adapting to
the Power Reference. Only to be used for
power sensor calibration.
08485-60005 A, P
2.4 mm (f) to Type-N (m) Shipped with the 8487A for adapting to
the Power Reference. Only to be used for
power sensor calibration.
08487-60001 A, P
Type-N Tee 1250-0559 P
a. Keysight or Hewlett-Packard model numbers unless otherwise noted.
b. A = Adjustments, P = Performance Testing, T = Troubleshooting
c. Supported PSG models:
E8244A
E8247A
E8254A
E8257C
E8257D
E8267C
E8267D
Note: One PSG with Option 567, 1EA/1EU, 1E1, 007, and UNX or UNR can be used as the Microwave
Signal Generator #1, Low Noise Signal Generator, and the RF Signal Generator.
Table 1-1 Required Test Equipment
Instrument Critical Specifications Recommended
Keysight Model
Number
a
or Vendor
Model Number
Alternative
Keysight Model
Number
a
Use
b