Figure 88. Air baffle installation
Step 3. Lower the air baffle into the chassis and press the air baffle down until it is securely seated.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 288.
Backplane replacement
Use this information to remove and install a backplane.
•
“Remove the front 2.5-inch drive backplane” on page 100
• “Install the front 2.5-inch drive backplane” on page 101
• “Remove the 2.5-inch rear drive backplane” on page 102
• “Install the 2.5-inch rear drive backplane” on page 104
Remove the front 2.5-inch drive backplane
Use this information to remove the backplane for four, eight, or ten 2.5-inch hot-swap drives.
About this task
The following describes how to remove the backplane for ten 2.5-inch hot-swap drives. You can remove the
backplane for four or eight 2.5-inch hot-swap drives in the same way.
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
100 ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
