Rack front
Figure 74. Securing the server to the front of the rack
Flip down the covers on the rack latches.
Tighten the screws to secure the server.
b. (Optional) Install one M6 screw to each of the rails to secure the server to the rear of the rack.
Rack rear
Figure 75. Securing the server to the rear of the rack
After you finish
1. Reconnect the power cords and any cables that you removed.
2. Power on the server and any peripheral devices. See
“Power on the server” on page 74.
3. Update the server configuration. See
“Complete the parts replacement” on page 288.
Remove the server from the rack (slide rails)
Follow instructions in this section to remove the server from the rack equipped with slide rails.
Chapter 5. Hardware replacement procedures 89
To Next Page
Loading...
