Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Install the rack latch.
Figure 234. Rack latch installation
a. On each side of the server, align the rack latch with the pin on the chassis. Then, press the
rack latch onto the chassis and slightly slide it forward as shown.
b.
Install the two screws to secure the rack latch on each side of the server.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 288.
Rear drive assembly replacement
Use this information to remove and install the rear drive assembly.
Remove the 2.5-inch rear drive assembly
Use this information to remove the 2.5-inch rear drive assembly.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
232
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
