VGA connector
The VGA connectors on the front and rear of the server can be used to attach a high-performance monitor, a
direct-drive monitor, or other devices that use a VGA connector.
XCC system management port (10/100/1000 Mbps RJ-45)
The XClarity Controller network connector can be used to attach an Ethernet cable to manage the baseboard
management controller (BMC).
Rear LEDs
• For more information about the LEDs on the XCC system management port, see
“LEDs on the XCC
system management port” on page 38
.
• For more information about the system error LED, RoT fault LED and system ID LED, see
“System-I/O-
board LEDs” on page 42
.
• For more information about the LEDs on the power supply unit, see
“Power-supply-unit LEDs” on page
40
.
Inlet and outlet hoses
The Processor Neptune
TM
Core Module (NeptCore) spreads two hoses out to connect to the manifolds. The
inlet hose conveys warm water from the facility to the cold plates to cool down the processors, and the outlet
hose conducts hot water out of the NeptCore module to realize system cooling.
Top view
This section contains information on the top views of the server.
The following illustrations show the top views of the server without any air baffle or rear drive cage installed.
•
“Top view with standard heat sinks” on page 28
• “Top view with NeptAir module” on page 30
• “Top view with NeptCore module” on page 31
Top view with standard heat sinks
This topic offers the top view of server models with standard heat sinks.
28
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
