Install the rear OCP interposer card
Follow the steps in this section to install a rear OCP interposer card.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 282.
Step 2. Install the rear OCP interposer card.
Figure 117. Installing the rear OCP interposer
a.
Slide the rear OCP interposer into the slot until it is fully seated.
b. Tighten the screw to secure the rear OCP interposer.
Step 3. Connect the cables to the rear OCP interposer card. For more details, see
Internal Cable Routing
Guide
.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 288.
Front I/O module replacement
Use this information to remove and install the front I/O module.
•
“Remove the front I/O module” on page 124
• “Install the front I/O module” on page 125
Chapter 5. Hardware replacement procedures 123
To Next Page
Loading...
