Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 282.
Step 2. Remove the drives or drive fillers installed in the 2.5-inch rear drive cage. See “Remove a 2.5-inch
hot-swap drive” on page 129
.
Step 3. Disconnect the 2.5-inch rear drive cage cables from the processor board or the PCIe adapter. See
Internal Cable Routing Guide.
Step 4. Hold the two blue touch points and directly lift the 2.5-inch rear drive cage out of the chassis.
Figure 235. 2.5-inch rear drive cage removal
Step 5. If the rear backplane is reused, remove the rear backplane. See “Remove the 2.5-inch rear drive
backplane” on page 102
.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the 2.5-inch rear drive assembly
Use this information to install the 2.5-inch rear drive assembly.
About this task
The following illustrates how to install the 2.5-inch rear drive assembly.
Attention:
• Read “Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 233
To Next Page
Loading...
